Differences

This shows you the differences between two versions of the page.

--- hall_effect_sensors [2019/03/20 23:09] – [Wiring] tell
+++ hall_effect_sensors [2019/03/20 23:13] (current) – [Alternative Hall Effect Sensor] tell
@@ Line 25: / Line 25: @@
 {{ :hall-sensor-dio.jpg?600 |}}
+Mounting the sensor with the part number down as shown makes it sensitive to the same pole of the magnet as the WCP sensors, allowing  this one to be dropped in without flipping a magnet over.
 The LEDs on the DIO test board indicate power and magnet-present, just like the LEDs on the WCP board.
-A drop of glue would be a good idea to hold it in place firmly.
+A big drop of glue would be a good idea to hold the sensor chip firmly to the board.
 We'd still have to figure out how to mount the DIO board.