Eastbots Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

The FRC Radio can accept "Passive Power Over Ethernet", 12-24vdc applied to the two unused pairs 
of Cat-5 cable wired for 100-base-T data.

After hand-crafting some PoE injector cables, we wanted to test them before putting them on the robot
and radio.  So we built a simple tester. 

====== Prototype ======

{{ :ppoe-tester.jpg?400 |}}

This prototype is hacked onto a scrap of a breakout board for an 8p8c jack.  It consists of two LEDs and two resistors.  

One LED lights if the brown and blue wires are recieving the correct polarity of DC power.  The other LED lights if the white/brown and white/blue wires are OK.  Using two independent [[basic LED circuit]]s allows us to test that all four wires are actually connected properly.  Since the two wires of each pair carry the same power, if one were broken the radio might still work - but there would be extra resistance and no redundancy in the defective cable.

====== Schematic ======
{{ :ppoe-test-sch.png?400 |}}